Set Mode; Set Mode Programming - Icom IC-M412 Instruction Manual

7

SET MODE

n Set mode programming
Set mode is used to change the conditions of the trans-
ceiver's functions: Scan type, Scan resume timer, Dual/Tri-
watch, Operation beep, LCD backlight, LCD contrast, AF
level adjustment and Favorite channel.
Available functions may differ depending on dealer set-
ting.
D SET MODE CONSTRUCTION
• Remote ID
Scrolls
• Favorite channel
Scrolls
• AF level
adjustment
44
• Scan type
Starting item
• To enter Set mode: While pushing
• To select the item: Push
• To exit Set mode: Turn power OFF, then ON again.
• LCD Contrast
Scrolls
q Turn power OFF.
w While pushing [16], turn ON the power to enter the Set mode.
• "SCAN" appears at the channel comment indicator.
e After the display appears, release [16].
r Push [16] to select a desired item, if necessary.
t Push [Y] or [Z] to select the desired setting of the item.
y Turn power OFF, then ON again to exit the Set mode.
• Scan resume
timer
, turn power ON.
. ( )
• LCD Backlight
Scrolls
• Weather alert
• Dual/Tri-watch
• Operation beep