Precautions - Icom IC-M412 Instruction Manual

PRECAUTIONS

RWARNING! NEVER
AC outlet. This may pose a fire hazard or result in an electric
shock.
CAUTION:
Changes or modifications to this device, not
expressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.
RWARNING! NEVER
power source of more than 16 V DC or use reverse polarity.
This will ruin the transceiver.
RWARNING! NEVER
the DC plug at the back of the transceiver and fuse holder. If
an incorrect connection is made after cutting, the transceiver
may be damaged.
CAUTION: NEVER
operation of the vessel may be hindered or where it could
cause bodily injury.
CAUTION: KEEP
away from the ship's navigation compass.
DO NOT
use or place the transceiver in areas with tem-
peratures below –4°F (–20°C) or above +140°F (+60°C), or
in areas subject to direct sunlight, such as the dashboard.
v
connect the transceiver to an
connect the transceiver to a
cut the DC power cable between
place the transceiver where normal
the transceiver at least 3.3 ft (1 m)
DO NOT
use harsh solvents such as benzine or alcohol to
clean the transceiver, as they will damage the transceiver's
surfaces. If the transceiver becomes dusty or dirty, wipe it
clean with a soft, dry cloth.
BE CAREFUL!
The transceiver rear panel will become
hot when operating continuously for long periods of time.
Place the transceiver in a secure place to avoid inadvertent
use by children
BE CAREFUL!
The transceiver employs waterproof
construction, which corresponds to IPX7 of the international
standard IEC 60529 (2001). However, once the transceiver
has been dropped, waterproofing cannot be guaranteed due
to the fact that the case may be cracked, or the waterproof
seal damaged, etc.
Approved Icom optional equipment is designed for optimal
performance when used with an Icom transceiver.
Icom is not responsible for the destruction or damage to an
Icom transceiver in the event the Icom transceiver is used
with equipment that is not manufactured or approved by
Icom.