HIOS HSV-10RB Instruction Manual page 9

5- . Checking and adjusting the passing plate
4
Turn OFF the power switch before making any checks or adjustments.
・ Check that the passing plate is adjusted to a height that permits loaded
screws to pass just within the clearance limit.
・ If the passing plate is too low, screws cannot pass.
If the passing plate is too high, it will hamper a smooth transport of the
screws.
・ If adjustment is required, loosen the passing plate attaching bolt and ad-
just the height.
・ After making an adjustment, do an operational check.
Note: Using the half-presses on both sides of the passing plate as guides,
slide the passing plate up or down.
5- . Checking and adjusting the rail vibration
5
This machine's rail vibration can be adjusted.
The screw transport speed differs depending on the screw type.
Check the screw transport speed. If the rail vibration hinders a smooth
transport of the screws, it can be adjusted.
・ Loosen the anti-vibration screw at the rear of the machine.
Next, turn the vibration adjusting screw, located on the bottom of the ma-
chine, to adjust the vibration.
When the screw is turned clockwise, as viewed from the bottom of the
machine, the vibration will increase.
When the screw is turned counterclockwise, the vibration decreases.
・ If the vibration is adjusted to a too large a value to increase the transport
speed, the rail will hit against the escaper and screws may fall into the
machine from the clearance, failing to unload screws normally. Adjust the
vibration to a proper value that matches the loaded screws.
(Related item: Check and adjust the front and rear positions of the rail.)
・ After making an adjustment, be sure to tighten the anti-vibration bolt.
・ After making an adjustment, do an operational check.
Loaded screw
The clearance should be just enough to permit the loaded screws
to pass through the passing plate.
Vibration adjusting
plate fixing bolt
Vibration
adjusting
bolt
Weaker
vibration
The rail must not come in contact with the escaper.
The clearance must not be too large.
- 8 -
Passing plate
attaching bolt
Passing plate
Half-press
(provided on both
sides of the pass-
ing plate)
Stronger
vibration