HIOS HSV-10RB Instruction Manual page 20

④ . Explanation of the escaper movement before adjusting
the sensor
When the power switch is turned ON, if there is no screw at the site
where the screw is to be extracted, the escaper rotates with the screw
sensor LED off.
The escaper rotates and accepts a screw from the rail.
As the escaper rotates, it brings the screw to the screw extraction site.
At this time, the sensor detects the screw, the LED lights up and the
escaper stops.
When the screw is removed from the extraction site, the LED light
goes off and the escaper rotates to accept another screw from the rail.
This is the correct sequence of operation. Usually, there is no need to
adjust the sensor as it was done when assembled in the factory.
The following are irregular situations that require adjustment:
- There is no screw at the extraction site but, the LED is on and the
escaper doesn't rotate.
- There's a screw at the extraction site, but the LED is not lit and the
escaper rotates.
Escaper
LED screw
sensor
Accepting a screw
LED screw sensor
OFF
When a screw is not at
the extraction site,
LED screw sensor
OFF.
[Reference]
- 19 -
Power switch
The screw is Extracting the screw
carried to the at the extraction site.
extraction site. LED LED screw sensor
screw sensor ON OFF
When a screw is at
the extraction site, LED
screw sensor ON.
The rotation of the escaper, in the opposite
direction, is a reference point run of the escaper
motor.
The rotation of the escaper, in the opposite di-
rection, occurs when the power is turned on and
the starting point of the escaper is not aligned
with the reference point of the escaper motor.
During regular operation, as in the figure above,
the escaper rotates clockwise.
Sensor
Screw
extraction
site