HIOS HSV-10RB Instruction Manual page 28

Trouble
9-3
A screw has fallen into the rail groove.
9-4
The flow on the screw rail is improper.
Cause
・Screws with a smaller diameter than the
specified rail size were loaded.
・Screws with a shorter total length than
the rail groove width were loaded.
・The clearance between the holding plate
and the head of the loaded screw is too
low.
・ Screws with a spring washer having one
increment smaller than the specified
nominal rail size were loaded.
・The rail is oily or dirty.
・The rail does not vibrate.
(A screw is caught in the clearance.)
・The motor is worn.
- 27 -
Corrective measures
・Use screws with the specified nominal
diameter and length.
・No corrective measure is available.
Consult our service section.
・Adjust the holding plate bracket assem-
bly. (Adjust the holding plate.)
Adjust the vibration.
If, after following the instructions written
above, the machine still does not function
properly, consult our service section.
・Clean the rail.
・Remove the screws caught in the clear-
ance.
If there is no screw that is caught, consult
our service section.
・Check that the vibration level is properly
adjusted.
・Replace the motor.
[Part No: HSVRB-09105-15]