Parts Adjustments And Replacements - HIOS HSV-10RB Instruction Manual

6. PARTS ADJUSTMENTS AND REPLACEMENTS

The brush and main motor are consumable parts. When using a different diameter of screw, the following items must be
replaced: rail, escaper and robot escaper guide.
These parts may be ordered separately. The replacing and adjusting procedures are described below.
When replacing any parts, a fine adjustment is required. Make these fine adjustments by reading the corresponding con-
tents carefully. Before replacing any parts, be sure to remove all the screws from the chamber.
6- . Replacing and Adjusting the Brush
1
Turn OFF the power switch before starting replacement and
adjustment.
If the brush is too worn to sweep screws off of the rail, replace it.
A brush with harder bristles, than the standard brush, is available as
an option. Consider its convenience when the situation requires it.
・ Turn ON and OFF the power switch in order to set the brush at the posi-
tion shown in the figure on the right and detach the brush assembly.
・ The brush assembly can be disassembled as shown in the figure on the
right.
・ For assembly, reverse the disassembling procedure.
・ After completing the assembly, check that the front part of the brush
doesn't come in contact with the passing plate. The ideal clearance is 0
mm.
・ For adjustment, refer to "Checking and Adjusting Before Operating the
Machine".
Part number of brush: HS3-02053 (standard brush)
Brush assembly attaching screw
Passing
plate
Brush as-
sembly
Brush bracket#2
- 12 -
Passing
plate
When the brush is operating, it
should not come in contact with
the passing plate.
Hex socket head small bolt
M2.6×10
Spring washer
M2.6
Plain washer
M2.6
Brush bracket#1
Brush
Brush