Adjustments And Checks Before Use - HIOS HSV-10RB Instruction Manual

5. ADJUSTMENTS AND CHECKS BEFORE USE

5- . Checking the model number of the main body
1
Check if the machine has the parts which match the nominal diameter of the
screws to be loaded. Check the model number of the rail, escaper, escaper
guide for the robot and passing plate by referring to the following table. Each
escaper is stamped with a model number which matches with the type of
screws that can be used. The escaper guide for the robot is stamped with a
model number which corresponds with the types of screws that can be used.
Screw feeder Screw Rail model
model size No.
HSV-10RB M1.0 HSV-RI-10
HSV-12RB M1.2 HSV-RI-12
HSV-14RB M1.4 HSV-RI-14
HSV-17RB M1.7 HSV-RI-17
HSV-20RB M2.0 HSV-RI-20
HSV-23RB M2.3 HSV-RI-23
HSV-26RB M2.6 HSV-RI-26
HSV-30RB M3.0 HSV-RI-30
Note: Screws, with a different nominal diameter, can be used by replacing the rail, escaper, passing plate
and the robot escaper guide for the robot. The parts, for replacement, are available separately.
Before delivery, each section of the machine is checked and adjusted with panhead screws matching the nominal diameters of
the ordered model. Most screws may be usable in the initial status of adjustment however, if the height or shape of the screw
head is different or if the operation is regarded as abnormal, each section must be readjusted. If this is the case, make the follow-
ing checks and adjustments:
○ Check the screw load amount
○ Check and adjust the rail vibration
○ Check and adjust the front & rear sides of the rail
If the rail, escaper, passing plate and robot escaper guide are replaced, screws with a different nominal diameter can be accept-
ed. After these parts are replaced, fine adjusting is required. The respective adjusting procedures will be described elsewhere.
Please read these procedures.
Escaper model Escaper guide of
No. the robot model No.
HSV-7017-10
HSV-7017-12
HSV-TPO00610-1
HSV-7017-14
HSV-7017-17
HSV-7017-20
HSV-7017-23
HSV-TPO00610-2
HSV-7017-26
HSV-7017-30
○ Check and adjust the brush
○ Check and adjust the holding plate
Passing plate iden-
tification seal
Passing plate
model No.
Escaper guide
for the robot
identification
HS3-02052-1
stamp
Escaper
identification
HS3-02052-2
stamp
○ Check and adjust the passing plate
○ Check and adjust the timer
- 6 -
Rail
identification
seal