HIOS HSV-10RB Instruction Manual page 15

○
Operation Timing After Replacing the Main Motor
Turn OFF the power switch before starting to replace and ad-
just the main motor.
・ To adjust the timing of the scooping block in respect to the brush move-
ment, it is necessary to adjust the gear engagement.
・ When the motor has been removed from the main body, adjust the gear
engagement of the motor, as shown in the figure on the right then the
operation timing can be adjusted. After assembling the motor, be sure to
tighten the screws again.
・ When it is hard to engage the driving gear, of the motor with the driven
gear, loosen the drive shaft bracket (right) then this will facilitate the as-
sembly. (Refer to the figure on the right.)
・ After installing the motor, switch the power ON to check the operation
timing. (Check that both right and left scooping blocks operate almost
simultaneously.)
・ After doing an operation check, return the wiring arrangement to its orig-
inal status. When installing the cover, be careful not to pinch any wires.
Be careful that the wiring does not hinder the operation of moving parts.
The wiring, on the inside, should not hinder adjustment made from the
outside of the machine.
NOTE:
→
To avoid breakage, do not use excessive force with the motor
wiring.
The left and right scooping blocks should be at the lowest position.
· Assemble the motor section when the scooping blocks left and right
are in the lowest position.
· To get the left and right scooping blocks at almost the same height,
clinch the drive gear of the motor shaft and the gears on the left
and right, and tighten the motor bracket. (M2.6 x 8 - 2 pieces)
When it is hard to get a proper gear engagement,
loosen the right driving shaft bracket then adjust the gears and
tighten the screws.
- 14 -
When the right
pin is vertical, the
left pin should be
inclined about 46°.
Right driving shaft bracket
Attaching screws at
4 positions