HIOS HSV-10RB Instruction Manual page 8

5- . Amount of screws to be loaded
2
An excessive amount of screws, loaded into the chamber, will have an
adverse effect on the screw alignment and transport. The figure, shown
at right, indicates the maximum amount of screws to be loaded. Use
this as a guide when loading the screws.
・ Turn the power switch ON and OFF so that the scooping block is at the
lower limit position.
・ Load screws up to approximately 2-3 mm below the rail surface.
・ At this time, check that screws are not loaded so as to cover the upper
portion of the inclined plate.
・ Be sure to determine the screw load by observing the machine while it is
in operation.
5- . Checking and adjusting the brush
3
Turn OFF the power supply before checking and adjusting.
Load the screws into the scooping chamber, turn ON and OFF the
power switch so that screws are aligned into the rail groove.
・ Turn ON and OFF the power switch so that the brush bristles are in a
horizontal position as shown in the figure at right.
・ Check that the heads of the screws, in the rail groove, are in slight con-
tact with the brush bristles.
・ When the brush height is too high or low, this will have an adverse effect
on the screw alignment and transport.
・ If any adjustment is necessary, loosen the brush height adjusting bolt to
adjust the brush height.
・ If the plastic portion, at the front of the brush, comes into contact with the
passing plate, loosen the brush assembly mounting screw and make an
adjustment either backward or forward.
・ Operate the machine to check that the brush operation is normal.
Screws, loaded into the chamber, must not be above the rail-groove
surface. (The maximum screw load must be 2-3mm below the rail-
groove surface.)
This inclined surface, on both the right and left inclined plates, should
be visible.
- 7 -
Power switch
Turn On and Off the power switch
to put the brush bristles in a hori-
zontal position.
Power switch
Move the brush by hand to check
that the screws, in the rail groove,
are in slight contact with the brush
bristles and make adjustments if
necessary.
Passing plate
Brush assembly at-
taching screw
The brush must not be in
contact with the passing
plate when it moves.
Brush height adjusting bolt
Brush
Loaded screws