HIOS HSV-10RB Instruction Manual page 29

Trouble
9-5
Screws tend to pass through the passing
plate in an abnormal position.
The axis of the screw thread tends to enter
the passing plate.
9-6
No screw comes to the extraction site.
9-7
The machine stops its operation suddenly.
Cause
・The passing plate is not adjusted properly.
・Too many screws are in the scooping
chamber.
・Screws are stopped while still on the rail.
・Screws cannot be transferred smoothly
from the rail to the escaper.
・The overload protective circuit was acti-
vated.
・Too many screws are in the scooping
chamber.
・A screw is caught in the clearance.
・A screw, at the extraction site, could not
be extracted for an amount of time.
- 28 -
Corrective measures
・Adjust the passing plate.
・Reduce the quantity of screws to a proper
level.
・Adjust the position of the holding plate.
・Adjust the distance between the end of
the rail and the escaper or adjust the
height of the escaper.
・Turn the machine OFF and then ON
again.
・Remove the cause of overload.
・Remove screws to a proper level.
・When the machine stops, even if the
screws are at a proper level, consult our
service section.
・Remove the screw that is caught.
・Remove the screw.