HIOS HSV-10RB Instruction Manual page 12

5- . Operation
9
○ Loading the screws (cf. p7)
・ Open the upper cover.
When the chamber plates are at their lowest position, load screws up to 2-3 mm below the rail groove surface.
・ Check that the screws are not loaded so as to cover the upper portion of the inclined plates.
[CAUTION] Do not overload the chamber with screws otherwise it may cause a malfunction or damage the machine.
○ Turning ON the power
・ Plug the attached AC adapter into the main body and power outlet.
・ When the power switch is turned ON, the power switch lamp lights up. The scooping block starts to move up and down. The rail
starts to vibrate and the escaper starts rotating.
・ Screws move along the rail towards the rotating escaper which selects one screw at a time.
・ The escaper rotates and deposits the selected screw at the extraction site.
・ At this moment, the sensor detects a screw and the screw sensor LED lights up and then the operation stops.
・ Until a screw is extracted, the machine stops operating.
・ When a screw is extracted, the sensor detects this and the sensor LED light goes off and the machine resumes operation.
[CAUTION] Do not use any AC adapter other than the one included with this unit, as it may cause damage.
5- . Maintenance
10
A dirty rail groove may interfere with the screw transport speed.
Clean the dirty rail with a soft, clean cloth dipped in alcohol.
If cleaning is difficult, remove the rail from the machine and clean the
rail groove. Before removing the rail from the machine, be sure to
turn off the power supply and take the screws out of the chamber.
If there is any dirt or a flaw in the rail groove that may cause an im-
pediment in use, we recommend the user to clean or replace the rail.
Loosen the rail fixing bolts and pull out the rail assembly
from the rear side of the machine.
Clean the rail groove.
- 11 -
Rail fixing bolt