HIOS HSV-10RB Instruction Manual page 24

7- . External output signal line
3
The wires coming out from the back of the machine serves as the de-
tection of presence on the rotational escaper, which shall be use with
automatic assembly machines or external screw counters.
Screw present :Signal high(ON)
[Function]
Incoming current: shall be limited to less than 100mA
**CAUTION: Additional resistor is required on externally cir-
cuit for regulating current**
[Capacity]: Max DC current: 100mA
External supply voltage: 5-24VDC (Max. 27V)
[Caution] :Please keep the length of output signal wire less than 3m;
*The purple wire functions as signal output high(Collector end),
with the gray wire as common
Purple line －－－ ＞ Signal line (OFF when no screw is present)
Gray line －－－ ＞ Common line
Circuit diagram of the signal lines
Inside of the feeder
Vcc1
5V
GND
(On when a screw is present)
Outside of the feeder
R
2.2kΩ 1/ 4w
ZHR-2
OUT
JST
２
２
Purple line
１
１
CN10 Gray line
Vcc2
24V
D
LED-C
GND
- 23 -
Grommet
Signal line
(CN10)