Danfoss VLT FC 300 Instruction Manual page 37

VLT ® Automation Drive FC 300
Instruction Manual High Power
Ordering Information
Rittal TS-8 Enclo-
sure
70.9 in [1800 mm]
78.7 in [2000 mm]
86.6 in [2200 mm]
Kit Contents
•
•
•
•
•
All fasteners are either:
•
•
3.4.1. Installation of Rittal Enclosures
This illustration shows the full size template
included with the kit and two drawings that
may be used to locate the cut-outs for the top
and bottom enclosure plates. The duct work
may also be used to locate the openings.
Frame D3 Kit Part
No.
176F1824
176F1826
Ductwork components
Mounting hardware
Gasket material
Delivered with D1 and D2 frame kits:
• 175R5639 - Mounting templates and top/bottom cut-out for Rittal enclosure.
Delivered with E1 frame kits:
• 175R1036 - Mounting templates and top/bottom cut-out for Rittal enclosure.
0.39 in [10 mm], M5 Nuts torque to 2.3 Nm (20 in-lbs)
T25 Torx screws torque to 2.3 Nm (20 in-lbs)
MG.33.U1.22 - VLT ® is a registered Danfoss trademark.
Frame D4 Kit Part Frame E2 Part No.
No.
176F1823 Not possible
176F1825 176F1850
176F0299
3.29: Templates
3. How to Install
3
37