Safe Stop - Danfoss VLT FC 300 Instruction Manual

2. Safety Instructions and General Warning

2.1.7. Safe Stop

The FC 302 can perform the safety function
61800-5-2) or
2
It is designed and deemed suitable for the requirements of Safety Category 3 in EN 954-1. This
function is called safe stop. Prior to integrating and using safe stop in an installation, a thorough
risk analysis must be carried out on the installation in order to determine whether the safe stop
functionality and safety category are appropriate and sufficient. In order to install and use the
Safe Stop function in accordance with the requirements of Safety Category 3 in EN 954-1, the
related information and instructions of the FC 300 Design Guide MG.33.BX.YY must be followed!
The information and instructions contained in the Instruction Manual are not sufficient for a correct
and safe use of the safe stop functionality!
10
Stop Category 0
(as defined in EN 60204-1).
MG.33.U1.22 - VLT
Safe Torque Off
(As defined by draft CD IEC
® is a registered Danfoss trademark.
VLT ® Automation Drive FC 300
Instruction Manual High Power