Inkjet Print Cartridge; Removing The Inkjet Print Cartridge - Unisys e-action Source NDP Installation And Operation Manual

Source capture network document processor
Table of Contents

Advertisement

Inkjet Print Cartridge

The Inkjet print cartridge for the multi-jet endorser is located near the rear of
the unit on the right side. The cartridge has a self-contained ink supply and
needs to be replaced when endorsements on documents are light or not
printed. Replace a used cartridge with a replacement cartridge from Unisys
Direct. For new units, you may need to install the Inkjet print cartridge that is
shipped with the unit.

Removing the Inkjet Print Cartridge

Remove the Inkjet print cartridge as follows:
Be sure the document processor is connected to an AC power source
before removing the covers. Otherwise, electrostatic discharge may
damage the unit.
1. Remove the top-right unit cover. Refer to Figure 5-3.
2. Make a note of the position (bottom, middle, or top) of the Inkjet print
cartridge.
3. Grasp the cartridge positioning lever as shown in Figure 5-17, and push it
down to its bottom position.
4326 6295–002
Removal and Replacement of Source NDP Components
Figure 5–17. Positioning the Inkjet Print Cartridge
Caution
5–13

Advertisement

Table of Contents
loading

Table of Contents