Removal and Replacement of Source NDP Components
Pocket Entry Cover
The pocket entry cover is located at the entrance to the pocket next to the
feeder. To remove, grasp and pull up on the cover as shown in Figure 5-5.
Replace by reversing the motion.
Separator Cover
The separator cover fits over the separator and is located near the track
entrance of the feeder. To remove, grasp and pull up on the cover as shown
in Figure 5-6. Replace by reversing the motion.
5–6
Figure 5–5. Pocket Entry Cover
Figure 5–6. Separator Cover
4326 6295–002