Table of Contents
Advertisement
Uninstalling a Source NDP Unit
Follow these steps to uninstall a Source NDP unit and prepare it for shipping in
the event the unit needs servicing or repair:
1. Make sure the Power On/Off switch shown in Figure 2-11 is in the Off (O
is depressed) position.
2. Disconnect the DC power cable attached to the power supply from the
rear of the document processor. Refer to Figure 2-12
4326 6295–002
Figure 2–11. Power On/Off Switch
Figure 2–12. Disconnecting the DC Power Cable
Source NDP Installation
2–11
Advertisement
Table of Contents
