Video Lens - Sony BRC-300 Service Manual

2-1-3. Video Lens

Removing
1. Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
2. Remove the camera cabinet upper assembly.
(Refer to steps 2 to 5 in Section 1-3-2.)
3. Remove the camera cabinet lower.
(Refer to steps 3 to 5 in Section 1-3-3.)
4. Remove the SE plate.
(Refer to steps 2 to 4 in Section 2-2-9.)
5. Remove the camera assembly.
(Refer to steps 5 to 13 in Section 2-1-1.)
6. Remove the shield chassis.
(Refer to step 6 in Section 2-2-6.)
7. Remove the IF-110 board.
(Refer to steps 7 and 8 in Section 2-2-6.)
8. Remove the DD-208 board.
(Refer to steps 5 and 6 in Section 2-2-4.)
9. Remove the VC-343 board.
(Refer to steps 7 to 10 in Section 2-2-7.)
10. Remove the LED-418 board.
(Refer to steps 3 and 4 in Section 2-2-8.)
11. Remove the prism assembly.
(Refer to steps 11 and 12 in Section 2-1-2.)
12. Remove the five screws, and remove the board chassis
from the lens chassis assembly.
B2 x 3
BTP2 x 6
BTP2 x 6
BTP2 x 6
BRC-300/300P
BRU-300/300P
Lens chassis assembly
Board chassis
13. Remove the four screws, and remove the filter ring
from the lens chassis assembly.
14. Remove the two screws, and remove the video lens
from the lens chassis assembly.
Lens chassis assembly
Video lens
Filter ring
BTP2 x 6
BTP2 x 6
BTP2 x 6
2-5