Prism Assembly And Cd-389S Board - Sony BRC-300 Service Manual

13. Remove the camera assembly while slacking off the
flexible flat cable in the arrow direction.
Installation
14. Reattach the camera assembly in the reverse order
from steps 5 to 13.
15. Reassemble the unit in the reverse order from steps 1
to 4.
BRC-300/300P
BRU-300/300P
Camera assembly
Flexible flat cable

2-1-2. Prism Assembly and CD-389S Board

Removing
1. Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
2. Remove the camera cabinet upper assembly.
(Refer to steps 2 to 5 in Section 1-3-2.)
3. Remove the camera cabinet lower.
(Refer to steps 3 to 5 in Section 1-3-3.)
4. Remove the SE plate.
(Refer to steps 2 to 4 in Section 2-2-9.)
5. Remove the camera assembly.
(Refer to steps 5 to 13 in Section 2-1-1.)
6. Remove the shield chassis.
(Refer to step 6 in Section 2-2-6.)
7. Remove the IF-110 board.
(Refer to steps 7 and 8 in Section 2-2-6.)
8. Remove the DD-208 board.
(Refer to steps 5 and 6 in Section 2-2-4.)
9. Remove the VC-343 board.
(Refer to steps 7 to 10 in Section 2-2-7.)
10. Remove the LED-418 board.
(Refer to steps 3 and 4 in Section 2-2-8.)
11. Remove the three screws, and remove the three heat
sinks from the board chassis.
B2 x 3
Heat sinks
B2 x 3
Heat sink
Voids
Board chassis
2-3