Camera Cabinet Upper Assembly - Sony BRC-300 Service Manual

2. Return the lens forward, and remove the four screws.
3. Release the two hooks of the side rear assembly from
the pins of the tilt chassis, and remove the side front
assembly.
Side front assembly
PSW2.6 x 6
Tilt chassis
Installation
4. Reattach the side rear assembly and the side front
assembly in the reverse order of removal.
BRC-300/300P
BRU-300/300P
PSW
Hook
2.6 x 6
Pin
Hole

1-3-2. Camera Cabinet Upper Assembly

Removal
1. Remove the side rear assembly and the side front
assembly. (Refer to steps 1 to 3 in Section 1-3-1.)
2. Turn the lens upward.
3. Release the two hooks of the camera cabinet front
using a flat-head screwdriver as shown in the figure,
and remove the camera cabinet front.
Camera cabinet
front
Lens
Flat-head screwdriver
Hook
1-3