Tilt Motor - Sony BRC-300 Service Manual

2-1-6. Tilt Motor

Removing
1. Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
2. Remove the DR-526 board.
(Refer to steps 2 and 3 in Section 2-2-5.)
3. Remove the two tapes A shown in the figure.
Tapes A
2-8
4. Remove the three screws, and remove the motor plate.
5. Remove the four screws, and remove the tilt motor
from the motor plate.
Motor plate
Installation
6. Reattach the tilt motor in the reverse order from steps
3 to 5.
m
. Pay attention not mix up the screws (PSW.SRW2.5
x 6) and the screws (PSW2.6 x 6).
. Replace the tapes A with new ones.
7. Reassemble the unit in the reverse order from steps 1
and 2.
PSW.SRW2.5 x 6
PSW.SRW2.5 x 6
PSW2.6 x 6
PSW2.6 x 6
Tilt motor
BRC-300/300P
BRU-300/300P