Dr-526 Board - Sony BRC-300 Service Manual

2-2-5. DR-526 Board

Removing
1. Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
2. Remove the two screws, and remove the DR plate.
3. Disconnect the harness from the CN2503 on the DR-
526 board.
4. Disconnect the flexible flat cables from the connectors
(CN2501, CN2502) on the DR-526 board.
5. Remove the two screws, and remove the DR-526
board from the DR plate.
PSW2.6 x 6
Installation
6. Reinstall the DR-526 board in the reverse order from
steps 2 to 5.
7. Reattach the side rear assembly and side front assem-
bly. (Refer to step 4 in Section 1-3-1.)
BRC-300/300P
BRU-300/300P
DR plate
DR-526 board
PSW2.6 x 6
CN2501
CN2503
CN2502
2-2-6. IF-110 Board
Removing
1. Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
2. Remove the camera cabinet upper assembly.
(Refer to steps 2 to 5 in Section 1-3-2.)
3. Remove the camera cabinet lower.
(Refer to steps 3 to 5 in Section 1-3-3.)
4. Remove the SE plate.
(Refer to steps 2 to 4 in Section 2-2-9.)
5. Remove the camera assembly.
(Refer to steps 5 to 13 in Section 2-1-1.)
6. Remove the four screws, and remove the shield
chassis.
n
When removing the shield chassis, remove the two
tapes A.
Shield chassis
Tape A
B2 x 3
Tape A
BTP2 x 6
Camera assembly
2-15