Attaching The Lens To The Camera - Sony HDC2000 Operation Manual

Attaching the Lens to the Camera

Attach a hanger-mount-type lens recommended by Sony. For
details on the lens, refer to the instruction manual supplied
with the lens.
To attach, proceed as follows:
Lens
1
Loosen the lens-lock knob and turn the lens lock
counterclockwise to the horizontal position.
2
Align the pin on the lens with the U-shaped notch,
then hook the edge of the lens on the projection of the
camera.
3
Couple the lens to the camera.
4
Turn the lens lock clockwise, then fasten the lens-
lock knob.
U-shaped notch
Pin
Edge
Lens-lock knob
Note
Be sure to check the following two points before attaching the
lens:
• That the pan-lock and tilt-lock levers on the tripod are fixed.
• That there is not a pin at part A on the lens shown in the
figure below (if there is, remove it). If the pin cannot be
removed, consult your Sony representative.
Projection
Lens lock
13