Wireless 802.11 General Settings - Intermec PC23 User Manual

Wireless 802.11 General Settings

PC23 and PC43 Desktop Printer User Manual
Setting
Odometer (Current
Printhead)
Replace Printhead
Clean Printhead
Faulty Dot
Ribbon Low
Diameter
This section describes the 802.11 general settings. To view these
settings:
• From the printer Main Menu, select Settings > Communications
> Wireless 802.11 > General.
• From the printer home page, click the Configure tab >
Communications > Wireless 802.11.
Description
Sets the length of media (in meters) that the
printer prints before the Odometer (Current
Printhead) alert is sent, if this alert is
configured. Unit of measurement is defined
in the Unit of Measure parameter. Range is 0
to 4294967295.
Sets the length of media (in meters) that the
printer prints before the Replace Printhead
alert is sent, if this alert is configured. Unit of
measurement is defined in the Unit of
Measure parameter. Range is 0 to
4294967295.
Sets the length of media (in meters) that the
printer prints before the Clean Printhead
alert is sent, if this alert is configured. Unit of
measurement is defined in the Unit of
Measure parameter. Range is 0 to
4294967295.
Sets the number of faulty dots on the
printhead before the Faulty Dot alert is sent,
if this alert is configured. Range is 0 to
4294967295.
Sets the minimum diameter of the ribbon
roll before the Ribbon Low alert is sent, if this
alert is configured. Range is 0 to 200 mm.
Chapter A —
Default
0
0
0
0
147