Interrupt Switches - Renesas RTK79210**B00000BE User Manual

RZ/A2M SUB Board RTK79210XXB00000BE
2.6

Interrupt Switches

RTK79210XXB00000BE is equipped with an RZ/A2M NMI and IRQ0 interrupt signal input push switches (NMI
switch and IRQ0 switch).
The interrupt signal from IRQ0 RZ/A2M can be used to cancel the RZ/A2M deep standby mode. However, because
the IRQ0pin is shared with the Ethernet PHY1 and Ethernet PHY2, when using the IRQ0 switch, the user must connect
JP2 with the 2-pin of JP1.
Figure 2.6.1 shows an interrupt switch block diagram, and Table 2.6.1 shows a jumper JP1 function setting table.
NMI Switch
(SW2)
IRQ0 switch
(SW3)
Figure 2.6.1 Interrupt Switch Block Diagram
Table 2.6.1 Function Settings for Jumper JP1
Jumper
JP1 PJ_1 is used as Ethernet PHY1
WOL signal interrupt pin.
[Note] indicates setting functions.
R20UT4398EJ0100 Rev.1.00
2018.10.11
3.3V 3.3V
+
EthernetPHY1.WOL
3.3V 3.3V
JP1
JP2
1
3
+
EthernetPHY2.WOL
1-2
PJ_1 is used as Ethernet PHY2
WOL signal interrupt pin.
RZ/A2M (U1)
NMI
（DSTBY release）
PJ_1 / IRQ0
Note: Red text indicates a function used .
：Indicates a function not implemented .
：Indicates a SUB board .
2-3
2. Function specifications
2-JP2
PJ_1 used as IRQ0 switch (SW3)
interrupt pin (default setting)
2-28