Installation Guide
5.4.
Factory reset of Danfoss Link™ CC
Danfoss Link™ CC can be reset to factory settings, when all devices are
!
removed from the network.
Remove the front cover and press and hold the reset button, on the right side of
the Danfoss Link™ CC, until the controller gives an audible signal. All rooms are
now deleted and the Danfoss Link™ CC is reset to factory settings.
6. Upgrading software version
Danfoss Link™ software is upgradable. New software versions are published on
www.link.danfoss.com.
1. Download the software upgrade to a USB key, and insert the USB key in the
USB port.
2. Remove the front cover and press the SETUP pin for 3 seconds to enter the
service area.
Service Options
1
Software
26
06/2013
Danfoss Link™ CC
Software
2
Software Upgrade
?
VISGL702
Hold
?
Danfoss Heating Solutions
USB key