Performing A Network Test - Danfoss Link CC Installation Manual

Central controller

Hide thumbs Also See for Link CC:

Table of Contents

Installation Guide

4.9.

Performing a network test

After finishing installation, perform a network test, to ensure that communica-

tion between all added devices and the Danfoss Link™ CC is stable.

Note! Do not perform the network test before the Danfoss Link™ CC is mounted in

its final position and ensure that all living connects® are out of mounting mode, see

instructions following the living connect®.

1. Turn off the battery pack.

2. Slide the Danfoss Link™ CC onto the previously

installed mounting plate.

3. The Danfoss Link™ CC will now power-up.

4. Remove the front cover and press the SETUP

pin for 3 seconds to enter the service area.

If there is uncertainty about the network performance, it is recommended to

perform a network test before the installation is completed entirely.

Danfoss Heating Solutions

Danfoss Link™ CC

VISGL702

06/2013

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the Link CC and is the answer not in the manual?