Performing A Network Test - Danfoss Link CC Installation Manual

Installation Guide

4 .9 . Performing a network test

After finishing installation, perform a network test, to ensure that communica-
tion between all added devices and the Danfoss Link™ CC is stable.
Note! Do not perform the network test before the Danfoss Link™ CC is mounted in
its final position and ensure that all living connects® are out of mounting mode, see
instructions following the living connect®.
1. Turn off the battery pack.
2. Slide the Danfoss Link™ CC onto the previously
installed mounting plate.
3. The Danfoss Link™ CC will now power-up.
4. Remove the front cover and press the SETUP pin
for 3 seconds to enter the service area.
If there is uncertainty about the network performance, it is recommended to
perform a network test before the installation is completed entirely.
Service Options
1
Status and Diagnostics
Danfoss Heating Solutions
Danfoss Link™ CC
Status and Diagnostics
2
Network
?
VISGL90N
Wireless Network Status
3
Start Network Test
?
GB
?
12/2014 21