Removing A Sim Card; Attaching Power Supply Blades; Power Supply And Blades; Attaching The Blades - Multitech MultiModem iCell User Manual

3. Insert the SIM card into the card holder with the contact side facing down as shown.
4. Verify that the SIM card fits into the holder properly and replace the cover.

Removing a SIM Card

To remove the SIM card:
You need:
Phillips screwdriver
Needle-nose pliers
1. Disconnect power, if it is connected.
2. Use a small Phillips screwdriver to remove the two SIM cover screws and remove the SIM door.
3. Use a needle-nose pliers to grasp the SIM card and pull it from the card holder. Do not touch the contact
with the pliers.

Attaching Power Supply Blades

Power Supply and Blades

If your device shipped with a power cord, attach the blades for your region.
Power
Supply no
blades

Attaching the Blades

To attach a power supply blade:
1. Remove the power supply cover (not shown). To do this, slide the lock down and hold it while you lift off
the cover.
®
MultiModem iCell MTCMR User Guide
Power
Power Supply
Supply with
EU blade
DEVICE ACTIVATION AND INSTALLATION
with NAM
Supply with
blade
Power
UK blade
Supply with
AU-NZ blade
Power
39