Quadra-Fire MT VERNON Owner's Manual page 8

MT. VERNON AE INSERT
Setting Comfort Level
READY
71
MENU
HEAT OUTPUT
1. Press and hold "UP" or "DOWN"
button to set desired temperature.
74
ºF
NOTE: Set temperature must be 3
degrees higher than room
temperature for appliance to
start.
SET COMFORT LEVEL
74
ºF
ON HOLD
DONE RESUME
2. Press "HOLD TEMP".
3. Press "DONE".
8
12:30 PM
Set at: 68
1. At the starting screen, press "HEAT
OUTPUT".
2. Use the "UP" button to change
"HEAT OUTPUT LEVEL" to
"MEDIUM-HIGH".
3. Press "DONE" twice or wait 15
seconds for starting screen to re-
appear.
Setting Heat Output
12:30 PM
READY
71
Hold at: Set at: 74
MENU
HEAT OUTPUT
Medium High
7036-187M
HOPPER OUT OF FUEL
ERROR LIST
Min Firepot Temp
RETRY
1. If the appliance has stopped
operating, check the wall control
screen. If it is showing "Min Fire
pot Temp" the hopper has run out
of fuel.
2. Fill the hopper with fuel and press
the "RETRY" button twice. The
first time turns on the back light,
the second time starts the retry
function.
12:30 PM
SHUTDOWN
71
Hold at: Set at: 74
MENU
HEAT OUTPUT
3. If the wall control screen changes
to a "SHUTDOWN" screen that
means your appliance has not
completed the full shutdown cycle.
Depending on where it was in the
cycle it can take from one to ten
minutes to restart.
When the shutdown cycle is
complete the wall control screen
will display "STARTUP". Continue
to Step 4.
12:30 PM
STARTUP
71
Hold at: Set at: 74
MENU
HEAT OUTPUT
4. If the wall control screen changes
to a "STARTUP" screen after
pressing "RETRY" that means
your appliance has already
completed the shutdown cycle.
You must wait until the wall control
screen displays the startup screen
and then put 1/2 cup of pellets in
the fire pot for a quick restart.
5. Be sure the hopper lid and glass
door are both closed.
August 13, 2018
SERVICE