Quick Start Guide - Quadra-Fire MT VERNON Owner's Manual

C. Quick Start Guide
NOTICE: Any button pressed will turn on the back-light. Wall control will automatically
revert back to the starting screen if there is no activity for 15 seconds; except for the
"CONFIRM FUEL CHANGE" screen.
Wall Control for Reference
Buttons
READY 12:30 PM
73
Set at: 73
Room
Temp
MENU
HEAT OUTPUT
Function Buttons
Turning on appliance
READY 12:30 PM
71
Set at: 68
MENU
1. At the starting screen, press
"MENU".
MENU
Set Comfort Level
Auto/Manual/Off
Fuel Type
User Settings
2. Highlight "AUTO/MANUAL/OFF".
Press "SELECT".
AUTO/MANUAL SETTINGS
Automatic
Manual
Manual
Off
3. Highlight "MANUAL". Press
"SELECT".
4. Press "DONE" twice or wait 15
seconds for starting screen to re-
appear.
August 13, 2018
Choosing Fuel Type
Up
Down
1. At the starting screen, press
"MENU" button once or twice until
"MENU" screen appears.
2. Highlight "FUEL TYPE" using the
"UP/DOWN" buttons to the right side
of the display. Press "SELECT".
3. Scroll down and highlight
"HARDWOOD PELLET" or your fuel
type.
4. Now press "SELECT" to choose
new fuel.
5. Press "DONE" to confirm fuel
change.
6. Press "DONE" twice or wait 15
seconds for starting screen to
reappear.
7. Fill the hopper with fuel. If the
hopper was completely empty
or has run out of fuel, put
approximately 1/2 cup of pellets into
the fire pot for a quick restart.
8. Be sure the hopper lid and glass
door are both closed.
12:30 PM
READY
71
Set at: 68
MENU
MENU
Set Comfort Level
Auto/Manual/Off
Fuel Type
User Settings
FUEL SELECTION
Softwood Pellet
Sunflower Seeds
Wheat
Hardwood Pellet
CONFIRM FUEL CHANGE
Please empty hopper
of old fuel type and
ensure firebox is clean.
Please refer to
section 8 in manual.
DONE
7036-187M
MT. VERNON AE INSERT
Choosing TEMP Appliance: °f or
°c
READY 12:30 PM
71
Set at: 68
MENU
1. At the starting screen, press
"MENU" button once or twice until
"MENU" screen appears.
MENU
Set Comfort Level
Auto/Manual/Off
Fuel Type
User Settings
2. Highlight "USER SETTINGS"
using the "UP/DOWN" buttons to
the right side of the display. Press
"SELECT".
USER SETTINGS
Temp Units F/C
Flame Height Adjust
Temp Differential
3. Highlight "TEMP UNITS F/C"
using the "UP/DOWN" buttons to
the right side of the display. Press
"SELECT".
4. Press the "UP" or "DOWN"
button to set desired temperature
appliance and press "SELECT".
5. Press "DONE" twice again, or wait
15 seconds for starting screen to
re-appear.
7