Babboe Curve Assembly Instructions Manual page 68

Tip
If you also have a rain tent, retrieve the instruction manual for it and perform the steps for
installing the rain tent now. It will be easier to install it at this stage than after the bike
has been fully assembled.
1. Attach the bottom section of the front panel to the sub-frame using a short bolt (see
figure 27 and detail Q). Place the two plastic washers (1) between the front panel and
the connection point in the sub-frame.
2. Next, attach the front panel to the connection profiles (front) using the six long bolts
with 2 brackets (see figure 28 and detail R).
Please note
Adhere to the specified order for nuts, bolts and washers to ensure optimal assembly.
See detail Q and R for the correct order.
29
3. Stick the rubber strip onto the edge of the bottom panel, as shown in figure 29.
Make sure to press down on the strip to properly secure it.
Please note
If the rubber strip it too long, secure the strip and cut off the excess length.
68