Table of Contents
Advertisement
4. Crossbars
To replace top two crossbars (kit number 030024K) remove screws in side rails using a T-
40 Torx wrench. Loosen RIGHT side of bottom crossbar with a T-40 Torx wrench. Gently
tap the side rail with a soft rubber mallet to break the seal.
To replace the bottom cross bar (part number 030034), make sure the battery is not
inserted. Unplug the main wiring harness from the control box (see Figure 3c), and then
remove safety flap (see page 19), remove left wheel (see page 22), and remove right and
left battery clamps (see page 7). Remove the red plastic cover on bottom of crossbar
stabilizer arm by prying at the top in the middle with a small flat screwdriver, and then pry
each side at the bottom. Be careful to not break the two small plastic nubs on the bottom.
Fig. 4b
Fig. 4a
Tap in
direction
of arrow
Fig. 4c
Small plastic nubs
8
Advertisement
Table of Contents
