Table of Contents
Advertisement
Fig. 17a
Unscrew so it is secured by approximately three threads only. Gently pound on the head of
the screw with a hammer to move the bushing out just enough to move the swing arm.
Repeat on the other side. Work swing arm assembly back and forth to remove. To change
oil, remove piston rod and drain oil completely; replace with 1.75 ounces of SAE 90W Gear
Lube.
!
Caution !
When removing piston rod, do so carefully because oil will flow out once
removed.
18. Wheel
To change a flat tire, use a flat screwdriver to pop off the black plastic wheel cap. Then, use
an 8mm Allen wrench to remove the shoulder bolt.
Fig. 18a
When the bolt is removed, pull off the tire by hand. Next make certain all air pressure is
released and disassemble the wheel hub using an 8mm socket wrench, noting the location
of each bearing and the bushing. Split the hub. Once the hub is split, remove each side of
the hub and remove the damaged inner tube. Insert the new tube into the tire.
Fig. 17b
Fig. 18b
25
Advertisement
Table of Contents
