Table of Contents
Advertisement
Remove handle brackets to the frame with a T-40 Torx wrench. Remove handle and gently
pull the wires through.
Fig. 11b
Remove nose plate (see page 17). Remove wheels (see page 22). Remove all screws in
the left, side rail. Remove left wheel guard (see page 24). Remove both wheel brackets
(see page 24). Remove left battery clamp (see page 7). Remove safety flap (see page 19).
Carefully pull wires one at a time through the frame at the hole above the wheels and
remove the side rail.
Fig. 11c
Remove aluminum motor cover (see Fig. 7a on page 11). Since removing this cover breaks
the silicone seal, scrape off old silicone and apply new silicone when reassembling.
!
Caution !
Notice the position of the wires under the aluminum motor cover for reassembly.
18
Advertisement
Table of Contents
