Electronic Card - Magliner Powered Stair Climber User Maintenance Manual

Remove swing arm assembly (see page 21). Rotate the chain guard out of the way. Locate
and remove the connecting link so chain comes off (see page 10). Using a 5mm Allen
wrench, remove the three bolts that hold the motor on from the inside.
Fig. 6b
Find where the motor wires come in at the bottom of the main panel and disconnect at the
splice. The drive motor should come off easily.
Fig. 6c
Splice to disconnect

7. Electronic Card

Note – Powered Stair Climbers purchased AFTER December 2016 have the 0051491
electronic card and appropriate housing for the card and DO NOT need the adapter kit
spacer or extra wiring harness. Use these adapter items when replacing the electronic
card in Powered Stair Climbers purchased BEFORE December 2016.
Models Purchased AFTER December 2016
To replace the electronic card (part number 0051491) remove four bolts on the aluminum
motor cover with a 7mm socket with ratchet. Since removing this cover breaks the silicone
seal, scrape off old silicone and apply new silicone when reassembling.
Fig. 7.1a Fig. 7.1b
11