-005146 for the SAL 170 model
Remove the aluminum motor cover with a 7mm socket wrench (see Fig. 7a). Since
removing this cover breaks the silicone seal, scrape off old silicone and apply new silicone
when reassembling. Unhook the main wiring harness from the electronic card (see Fig.
11d). Pull out both grommets that run the wires through to the electronic card by working
side to side.
Fig. 10b
11. Main Wiring Harness
Be sure the battery is removed. To replace the main wiring harness (part number 030126);
remove the control box (see page 7). It is not necessary to remove red handles and
O-rings. Disconnect the wires to the round up switch at the connector (see page 18). Cut
off both connectors leaving approximately 1" of wires for a guide when connecting for
reassembly.
Fig. 11a
17