Table of Contents
Advertisement
9. Handles
To replace red handles (see pages 39-41 for part numbers) pull out and unplug the round
up switch (see page 18). Then, remove the screws in the red handle with a #2 screwdriver.
Remove the right handle bracket screw (see Fig. 8 on page 12) with a T-30 Torx wrench.
Pull handle apart while being careful to not damage the main wiring harness that runs to
the round-up switch. Remove old red plastic handles and cut off old O-rings. Roll new O-
rings over top and position into grooves on new handles. A curved hook may be useful to
stretch and pull the new O-rings over the new handles.
10. Lifting Unit
With the battery in place, position the swing arm out of way so the bolts are easily reached
(see Fig. 6a). Then, remove the battery from the Powered Stair Climber so no power can
get to the unit.
To replace the lifting unit*, remove both wheels (see page 22) and remove safety flap (see
page 19). Remove thru rod with 13mm socket wrench, using a second wrench to hold the
other end in place while loosening.
* Lifting Unit part numbers:
-005133 for the SAL 110 model
-005134 for the SAL 140 model
Fig. 9
Fig. 10a
16
Advertisement
Table of Contents
