Wheel Bracket; Wheel Guard - Magliner Powered Stair Climber User Maintenance Manual

19. Wheel Bracket

Remove wheel (see page 22) and wheel guard (see below) on the same side as the wheel
bracket (part number 030037) you are replacing. Remove nose plate (see page 17).
Remove thru rod with a 13mm Allen wrench. Remove 2 bolts on nose plate bracket with a
13mm Allen wrench using a second wrench at the other end to hold in place while
loosening. Gently tap out of place with a soft rubber mallet.
For reassembly, loosely attach the wheel guard. Put the 2 bolts that connect the wheel
bracket to the nose plate bracket back in place. Insert the thru rod and tighten completely.
Tighten the wheel guard in place. Reattach nose.

20. Wheel Guard

To replace the wheel guard (part number 030077), remove wheel (see page 22) on the
same side as the wheel guard you are replacing to allow access. Remove the wheel guard
with a 13mm socket wrench.
Fig. 19
Fig. 20
27