Table of Contents
Advertisement
ADA-13110
7. FACTORY DEFAULT
8. TROUBLESHOOTING
Problem
I forgot the password
I changed the configuration and the
converter isn't functioning.
9. VERSIONS
Electronic versions:
Basic
Galvanic isolation:
1kV= from the power supply
3kV= from the power supply
1kV= 3-way
3kV= 3-way
Terminal & Terminal Cover:
Cover without inlets, screw terminal block
Cover with inlets, screw terminal block
Cover without inlets, plug-in screw terminal block
Isolation from the power supply allows transmitting signals: Tx, Rx, RTS, CTS, DTR, DSR, DCD of RS232 interface.
3-way isolation allows transmitting signals: Tx, Rx, RTS of RS232 interface.
Parameter
User name
Password
IP address
Operating mode
Bout rate[bits/sec]
Number of data bits
Parity Control
Number of stop bits
Flow Control
Restoring Default Settings according to steps below:
1. Disconnect the power of the converter,
2. Remove the cover of ETHERNET connector,
3. Press RESET "RST" and holding the button, connect the power of the converter,
4. Release the button after 20 sec. when the converter will start with default settings.
Restoring Default Settings deletes existing configuration and the proper configuration
should be loaded to the converter from the backup.
1. Enter in the Internet browser http://converter-ip-address,
2. Select the menu [Factory Default Settings] press [Restore].
ADA-13110 -
Value
root
dbps
Obtain an IP address automatically using DHCP
RealPort
9600
8
no
1
no
Solution
-
-
1
Order example:
2
Product Symbol: ADA-13110-1-2-3
3
1 – basic version of electronic,
23
2 – 1kV= galvanic isolation, from the power supply,
33
3 – cover without inlets, plug-in screw terminal block.
1
2
3
22
Advertisement
Table of Contents
