Table of Contents
Advertisement
ADA-11040
5.2.3. BAUD RATE CONFIGURATION OF RS485/RS422 PORT
After read out the configuration parameters, change baud rate of RS485/422 serial port in section [UART Setting]:
[8] select baud rate,
[9] press button [Change] to send the parameter to the converter.
5.2.4. FACTORY DEFAULT
Converter reset to factory default can be done by:
[10] button [Reset Module], but first has to be read the setting, by button [Read Setting].
Factory default.
Operate frequency
Baud rate
Frequency deviation
Transmission power
bandwidth reception
Baud rate
Data bits
Parity
Stop bits
6. TROUBLESHOOTING
Problem
I forgot what the transmission speed of the serial port
is and I can not read the configuration parameters.
6
8
Parameter
Wireless RF
RS485/RS422 serial port
You can only select next baud rates, open COM port [Open COM] and readout
the settings by button [Read Setting], until it succeeds.
7
5
10
9
Value
869 [MHz]
9600 [bps]
35 [kHz]
20 [dBm]
105 [kHz]
9600 [bps]
8
Non
1
Solution
12
Advertisement
Table of Contents
