Push the rebound damper into the cartridge tube until there is 104 mm
6
(length) of shaft extended. Do not push the damper into the tube any
further.
Insert the compression damper into the cartridge tube and slowly
7
push it into the tube. The rebound damper will slowly extend as the
compression damper is installed; this is normal.
Firmly push down and thread the top cap into the tube.
Tighten the top cap to the specified torque. The rebound damper
8
seal head will be tightened onto the other end of the cartridge tube
simultaneously.
104 mm
Top Cap / Cassette Tool
Top Cap / Cassette Tool
9 N·m (80 in-lb)
57
Damper Assembly