SRAM Rock Shox Yari 2019 Service Manual page 58

Pull the rebound damper to full extension.
9
Secure a plastic cable tie around the shaft 34 mm from the end of the
shaft.
Cover the purge hole with the secured towel.
10
Oil may exit the cartridge tube purge hole. Wear saftey glasses and
keep your eyes and face away from the purge hole when compressing
the rebound damper.
Slowly push the rebound damper shaft into the tube until the cable
11
tie contacts the seal head, then stop. Do not push the damper in any
further.
Slowly, pull the shaft out to full extension.
Repeat 3-5 more times. This will allow any excess oil and air to escape
from system.
Remove the bottom bolt. Remove the damper assembly from the vise
and clean it with a shop towel.
Do not remove the cable tie.
⚠ CAUTI ON
34 mm
58
Damper Assembly