Change The Indoor Unit Address Using A Remote Controller - Toshiba SMMS-e Quick Reference

Address Setup

Change the indoor unit address using a remote controller

To change an indoor unit address using a wired remote controller.
The method to change the address of an individual indoor unit (the indoor unit is paired with a
wired remote controller one-to-one), or an indoor unit in a group.
(The method is available when the addresses have already been set automatically.)
(Execute it while the units are stopped.)
1
SET
Push and hold the
(If 2 or more indoor units are controlled in a group, the first indicated UNIT No. is that of the head unit.)
2
UNIT LOUVER
Push the button (left side of the button) repeatedly to select an indoor unit number to change if 2
or more units are controlled in a group. (The fan and louvers of the selected indoor unit are activated.)
(The fan of the selected indoor unit is turned on.)
3
Push the TEMP. /
4
Push the TIME /
you want.
5
SET
Push the button.
6
UNIT LOUVER
Push the button (left side of the button) repeatedly to select another indoor UNIT No. to change.
4 6
Repeat steps to to change the indoor unit addresses so as to make each of them unique.
7
UNIT LOUVER
Push the button (left side of the button) to check the changed addresses.
8
If the addresses have been changed correctly, push the
SET DATA SETTING
3
TEMP.
5
TIMER SET
TIME
FILTER
8
RESET TEST SET CL
Finish
1
CL TEST
, , and buttons at the same time for more than 4 seconds.
buttons repeatedly to select
buttons repeatedly to change the value indicated in the SET DATA section to that
CODE No.
UNIT No.
R.C. No.
ON / OFF
4
2, 6, 7
for CODE No..
TEST
button to finish the procedure.
25