To Select Another System Address - Toshiba SMMS-e Quick Reference

Address Setup
24
To check all the indoor unit addresses using an arbitrary wired remote controller.
(When communication wirings of 2 or more refrigerant lines are interconnected for central
control)
(Execute it while the units are stopped.)
You can check indoor unit addresses and positions of the indoor units in a single refrigerant line.
When an outdoor unit is selected, the indoor unit numbers of the refrigerant line of the selected unit are indicated
one after another and the fan and louvers of the indicated indoor units are activated.
1
Push and hold the TIME
At first, the line 1 and CODE No.
(Select an outdoor unit.)
2
UNIT LOUVER
Push
3
SET
Push the
• The address of an indoor unit connected to the selected refrigerant line is indicated on the LCD display and
its fan and louvers are activated.
4
UNIT LOUVER
Push the
of the selected refrigerant line are indicated one after another.
• Only the fan and louvers of the indicated indoor unit are activated.

To select another system address

5
CL
Push the
• After returning to step
6
TEST
Push the button to finish the procedure.
S E T
1
FILTE R
R E S E T TE S T
6
3
/ and
(Address Change) are indicated on the LCD display.
the (left side of the button) and
button to confirm the system address selection.
button (left side of the button). Each time you push the button, the indoor unit numbers
button to return to step
2
, select another system address and check the indoor unit addresses of the line.
CODE No.
DAT A S E TTING
UNIT No.
R .C . No.
TE MP. ON / OFF
TIME R S E T
TIME
S E T C L
TEST
buttons at the same time for more than 4 seconds.
SWING/FIX
buttons repeatedly to select a system address.
2
.
2
4
5