Changing The Indoor Unit Address Using A Remote Controller - Toshiba MMD-AP0076BHP1-E Service Manual

Changing the indoor unit address using a remote controller

To change an indoor unit address using a wired remote controller.
The method to change the address of an individual indoor unit (the indoor unit is paired
with a wired remote controller one-to-one), or an indoor unit in a group.
(The method is available when the addresses have already been set automatically.)
3
8
(Execute it while the units are stopped.)
1
Push and hold the
(If 2 or more indoor units are controlled in a group, the first indicated UNIT No. is that of the head unit.)
2
UNIT LOUVER
Push the button (left side of the button) repeatedly to select an indoor unit number
to change if 2 or more units are controlled in a group. (The fan and louvers of the selected
indoor unit are activated.)
(The fan of the selected indoor unit is turned on.)
3
Push the TEMP.
4
Push the TIME
section to that you want.
5
SET
Push the button.
6
UNIT LOUVER
Push the button (left side of the button) repeatedly to select another indoor UNIT No.
to change.
4 6
Repeat steps to to change the indoor unit addresses so as to make each of them unique.
7
UNIT LOUVER
Push the button (left side of the button) to check the changed addresses.
8
If the addresses have been changed correctly, push the
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET
1
CL
SET
, , and buttons at the same time for more than 4 seconds.
/ buttons repeatedly to select
/ buttons repeatedly to change the value indicated in the SET DATA
ON / OFF
FAN MODE
SAVE VENT
CL SWING/FIX UNIT LOUVER
2, 6, 7
13 13 13 13 13
for CODE No.
– 45 –
4
5
button to finish the procedure.