Xerox VersaLink B70 Series User Manual page 216

Troubleshooting
3. Remove any jammed paper in the paper output area.
Note: If the paper is torn, remove all torn pieces from the printer.
4. To close Door C, push the door up firmly until it clicks into place.
5. To close Door A, push the door up firmly until it clicks into place, then close the Bypass Tray.
T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g P P a a p p e e r r J J a a m m s s
M M u u l l t t i i p p l l e e S S h h e e e e t t s s P P u u l l l l e e d d T T o o g g e e t t h h e e r r
Probable Causes
The paper tray is too full.
The edges of the paper are not even.
The paper is moist from humidity.
Too much static electricity is present.
Using unsupported paper.
216 Xerox ® VersaLink
User Guide
® B70XX Multifunction Printer
Solutions
Remove some of the paper. Do not load paper past
fill line.
Remove the paper, align the edges, and then reload
it.
Remove the paper from the tray, and replace it with
new dry paper.
Try a new ream of paper.
Use only Xerox ® -approved paper. For details, refer to
Supported Paper.