Setup Screen 2; Setup Screen 3 - Graco ProControl 1KE Instructions - Parts Manual

Setup Screen 2

Use this screen to set the upper and lower limits for
operator adjustment of flow rate percent and to select
your preferred pressure units.
Enter the screen to set or change
preferences.
Press to activate a field for editing or to
accept the highlighted selection on a
dropdown menu.
Move to the right when editing number
fields. Press again to accept the entry
when all digits are correct.
Set your desired upper (first data field)
and lower (second data field) fluid flow
percent set limits. The Operator can
adjust the percentage on Run Screen 1
only within these limits.
Pressure units — select from the
following drop down options.
Select if system has no pressure
transducer.
Exit data editing.
Move between Setup Screens, fields on
a screen, or to increment/decrement the
digits when editing number fields.
3A2614H
Key

Setup Screen 3

Use this screen to set your flow rate maximum and
minimum values and to select your preferred flow
rate units.
Enter the screen to set or change
preferences.
Press to activate a field for editing or to
accept the highlighted selection on a
dropdown menu.
Move to the right when editing number
fields. Press again to accept the entry
when all digits are correct.
Set your desired maximum (first data
field) and minimum (second data field)
flow rates. Flow rates outside of these
parameters will trigger an alarm. See
Setup Screen 4, page
disable the flow rate alarms.
Flow Rate Units - Select from the
following drop down options.
Select if system has no flow
meter.
Exit data editing.
Move between Setup Screens, fields on
a screen, or to increment/decrement the
digits when editing number fields.
Setup Screens
Key
28, to set or
27