Initialization Of Related Items By Change Of Setting - Mitsubishi Electric EMU4-FD1-MB User Manual

Initialization of related items by change of setting

Setting item
Phase wire system
Use of VT
Direct voltage
Primary voltage (Special primary voltage)
Secondary voltage
Primary current (Special primary current)
Secondary current
Electric power demand time
Current demand time
MODBUS®RTU address
MODBUS®RTU baud rate
MODBUS®RTU parity
MODBUS®RTU stop bit
Contact/pulse input
Contact reset status
Contact/pulse output
Pulse output unit
With or without CO2 indication
Equivalent CO2 setting
Harmonic current indication setting
Harmonic voltage indication setting
Operating time indication setting
Operating time measured item setting
Use of upper/lower limit alarm
Upper/lower limit alarm element
Upper/lower limit alarm value
Alarm delay time
Alarm reset method
Logging unit ID
Logging date clear confirmation
MODBUS®TCP IP address
MODBUS®TCP Subnet mask
MODBUS®TCP Default gateway existence
MODBUS®TCP Default gateway address
All settings are reset to factory default by the following operation.
Settings are only initialized. Integrated values (such as electric energy, reactive energy and operating time) are not changed.
Enter CANCEL display in setting mode and operate as follows to initialize all settings.
For entering CANCEL display, refer to procedures for setting. (
Setting mode
CANCEL display
Menu 1 Menu 2
●
●
●
●
○
○
○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○
Symbol Meaning
Initialized
○
Change to default value corresponding to phase wire system
●
Initialized when the upper limit of pulse count is set and input method is changed from pulse to contact.
□
None Not initialized
page 16)
DISP - / RESET
Press both and
at the same time for 2sec.
(31/71)
Changed setting value
Menu 3
□
□
□
Initialization completed
Measurement display
Menu 4 Menu 5
○
○