Mitsubishi Electric EMU4-FD1-MB User Manual page 28

Setting menu 4: Upper / lower limit alarm setting, alarm delay time ,alarm reset, etc.
(4) Alarm delay time
DISP
SET
(5) Alarm reset method
SET DISP
Setting menu
Operations in alarm value setting display are as follows:
Setting of "Upper / lower limit alarm value"
+ / PHASE - / RESET
･ Press or
SET
･ Press for the setting digit (flashing digit) to shift to lower.
DISP
･ Press for the setting digit (flashing digit) to shift to upper.
･ Setting range is different for each alarm element. (refer to previous section)
Caution: In case the value is set to outside-set-value, indicate the error (E005)
When indicating the error, press
value again.
SET
･ Press at the lowest digit to transition to (4) Alarm delay time .
Set the delay time from fulfilling alarm occurring condition.
Set the alarm delay time if you want to avoid the alarm
caused by such as instant overload and noise.
Once setting, the alarm does not occur unless the time of
exceeding the upper / lower limit alarm value is over the specified
delay time.
In setting display, "s" means "second" and "M" means "minute".
0s 30s
5s 40s
10s 50s
20s 1M
Set the alarm reset method in alarm occurrence.
Alarm reset method
(Setting value)
Auto-reset Reset the alarm automatically when alarm occurring condition
(Auto) is gone.
Self-retention The alarm is held even after alarm occurring condition is gone.
(HoLd) Button operation is necessary to clear the alarm.
Complete the setting or continue in other menu according to procedures for setting.
For procedures for setting,
(27/71)
to choose the value at flashing digit.
to check the setting values and set the new
SET
2M
3M
4M
5M
Summery (For details,
page 16
page 54)